PRELIMINARY INFORMATION

FASTENER SUPPLIER (EGC/CUSTOMER):
QUANTITY:
STUD TYPE (ALL THREAD/CUSTOM):

BASIC DATA (REQUIRED)

NOMINAL DIAMETER (in):
NOMINAL LENGTH (in):
MATERIAL:
GRADE:
THREADS PER INCH:
THREAD TYPE:
THREAD MFR PROCESS (ROLLED/CUT/OTHER):
NUT HEIGHT:
JOINT THICKNESS / CLAMP LENGTH (in):
TENSIONING METHOD (HYDRAULIC/ROTATIONAL):
TENSIONING END ***:
COATING, PLATING, ETC.:
STAND OFF* (in):

* - THE STAND OFF ON A BOLT IS ONLY NECESSARY IF THE FASTENER IS TO BE MODIFIED AT THE THREADED END. STAND OFF IS DEFINED AS THE DISTANCE FROM THE BOTTOM OF THE NUT TO THE TOP OF THE FASTENER, EXCLUDING THE ROTABOLT CAP. A MINIMUM OF FULL NUT ENGAGEMENT IS REQUIRED.

** - THE K VALUE IS ONLY REQUIRED FOR LUBRICATED, PLATED, OR COATED THREADS.

*** - WHEN FASTENERS ARE TO BE INSTALLED USING HYDRAULIC TENSIONING, THE CUSTOMER MUST SPECIFY WHICH END THE TENSIONER WILL BE APPLIED TO.

PRELOAD SETTING (1 OF 3 REQUIRED)

1) LOADING (lbs):
2) LOADING (psi):
3) TORQUE (FT-LBS):
THREAD LUBRICANT (y/n): Choose Yes No
** K VALUE:

ADDITIONAL INFORMATION

IN-PROCESS TEMPERATURE RANGE:
ADVERSE ENVIRONMENTAL CONDITIONS:
MISCELLANEOUS INFORMATION:

ENGINEERING FIELDS:

PIN SIZE:
TENSILE STRESS AREA:
PUBLISHED YIELD (ksi):
CALCULATED YIELD (lbs):
PERCENTAGE OF YIELD:
CALCULATIONS:

CUSTOMER APPROVAL (REQUIRED):

CUSTOMER APPROVAL CONTACT NAME:
CUSTOMER APPROVAL CONTACT PHONE:
LOADING APPROVAL:

Rev 10/01